Texture Installation Guide

A successful installation begins with proper surface preparation and correct application techniques. Following the recommended process helps achieve a uniform finish, strong adhesion, and long-lasting performance.

Surface Preparation

The surface should be clean, dry, and structurally sound before application.

  • Remove dust, dirt, grease, loose paint, and other contaminants.
  • Repair cracks, holes, and uneven areas.
  • Ensure newly plastered surfaces are fully cured.
  • Apply a suitable primer before application.

Proper surface preparation is essential for achieving optimum adhesion and finish quality.

Product Preparation

  • Stir the material thoroughly before use until a uniform consistency is achieved.
  • Do not dilute unless recommended by the manufacturer.
  • Where possible, use material from the same batch on a continuous surface to maintain colour consistency.

Application

Apply the product using a clean stainless steel trowel.

  • Spread the material evenly across the prepared surface.
  • Maintain a consistent application thickness.
  • Complete one wall section continuously to minimize visible joints.
  • Follow recommended application practices throughout the project.

Professional application is recommended for the best decorative results.

Drying and Care

Allow the coating to dry naturally.

  • Protect freshly applied surfaces from rain, excessive moisture, and dust during the drying period.
  • Avoid application during unsuitable weather conditions.
  • Drying time may vary depending on temperature, humidity, and ventilation.

Maintenance

Routine maintenance helps preserve the appearance of the finish.

  • Clean periodically using water and a soft brush or cloth.
  • Avoid abrasive cleaning methods and harsh chemicals.
  • Repair any damaged areas promptly when necessary.

Important Note

Application methods and performance may vary depending on surface condition, environmental factors, and workmanship. Always follow the product instructions and conduct a small trial application when working on unfamiliar substrates.